Precise on smear
Aluminum tube on tip for more accurate smear
Lengthen the glue opening, deep into the gap, point-to-point bonding
strong adhesives on various surface as corkwood, plastic, rubber,metal,paper,leather and so on
More smooth on use and fast dry
Super glue use steps
|Open the glue bottle cap||Apply glue evenly on the surface|
|Press for 30s to fix||Full strength|
Adhesive test for ceramics
Adhesive test for metal
1.Use in a well-ventilated environment.
2.Children do not use, may be irritating to the skin and eyes, do not contact with eyes and skin. If contact, please wash with water, and looking for a doctor.
Stored in a cool and dry place 20-25 Degrees Centigrade without light.
-65°F to 180°F (-54 to 82°C)
Aluminum tube Full Blister
Use acetone or acetone-based nail polish remover.
● Saturate a cotton ball in acetone or acetone-based nail polish remover.
● Hold the saturated cotton on the glue spot to soften the adhesive.
● After it has softened the glue, wipe away the glue with the cotton ball or microfiber cloth.
● Repeat as necessary.
If you don't have acetone, you can use the following solution to get super glue off the glass.
1. Aqueous detergent solution (Mix dish soap and warm water in a ratio of 1:4)
4. Spray lubricant
Follow the above steps to remove super glue from glass
Super glue should neverbe usedon fake nails. Super Glue wasn't made tobe usedon your body, it will be irritating to your natural nails, which can lead to thembeing damaged.
Super glue, also referred to as cyanoacrylate glue or CA glue works on many types of plastic. But, we do not recommend it for use on polypropylene (PP) or polyethylene (PE) plastics or any type of rubber with high oil or plasticizer content.
A quality super glue, such as Hopson Super Glue Liquid (3g bottle), dries and sets in seconds. The glue fully cures in 24 hours. If you want to make super glue dry faster, raising the temperature is the easiest way to speed up the cure of One Component cyanoacrylate adhesives. You can use a hairdryer on a low setting to heat the glue, every 8°C degrees rise in temperature; the cure time is halved. The maximum temperature will vary between products.